![]() Please advise if you want it to always show. Press button 5 to move print head to the middle of the build platform. Customer Requested Parameters/Triggers normally, if a minimum TUR of 4:1 is met at the test point then guard-banding will not show at that test point. User manual instruction guide for Cetus 3DP-18 Beijing TierTime Technology Co. Please advise if you require a different Z-Factor. Determination of Z-Factor (Z%) unless otherwise specified by the customer, Cal Lab’s policy is to apply a Z-Factor of 30% of the Estimated Measurement Uncertainty (EMU). Normally this is set to automatic and will only show guard-banding based on the TUR at each test point. † Guard-banding will be triggered and displayed at the test point when the TUR is less than 4:1. Measurement guard-banding reported on the certificate of calibration †.Test Uncertainty Ratio (TUR) reported on the certificate of calibration.ANSI/NCSL Z540.3-2006 accredited calibration.Measurement Uncertainties reported at a coverage factor of k = 2, which for a normal distribution corresponds to a coverage of approximately 95%.A Certificate of Calibration traceable to NIST which contains the accredited calibration logo and our registration number. ![]() ![]() Measurement Uncertainties reported at a coverage factor of k 2, which for a. Notification of Out of Tolerance Conditions. All As Found and As Left data readings. ISO/IEC 17025:2017 Accredited Calibration.4Put a paper in between the Nozzle and Platform, lower the nozzle and feel the drag be- but user should able to feel a small drag from the nozzle. 3Use the + button to lower the Nozzle to close proximity of platform. Complies with ISO 9001:2015, ISO/TS 16949, AS9100, 10CFR50, and 10CFR21 nuclear requirements. 2Press button 5 to move the Nozzle to the middle of the build platform.ISO/IEC 17025:2017 Accredited Calibration.A Certificate of Calibration traceable to NIST.As Found out of tolerance data readings only.Notification of Out of Tolerance Conditions.Compliance with ISO 9001:2015 requirements.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |